Polycom KIRK KWS1500 - Manual (Page 39)

KIRK Wireless Server 1500 Installation and Maintenance
72160400_issue_B 39
1. Connect the power supply cable into the RJ11 connector in the bottom of the
repeater. For repeaters with external antenna, connect the external antenna cable
to the antenna connector in the rear of the repeater as well.
2. Mount the repeater onto the wall using the screws accompanying the repeater.
The external antenna used for the transmitter is to be fixed-mounted on
indoor permanent structures providing a separation distance of at least 20 cm
/ 8 inches from all persons during normal operation and must not be co-
located or operating in conjunction with any other antenna or transmitter.
The maximum radiated output power is 1W e.i.r.p. For more information and
technical support, please refer to www.polycom.com
Recording the Installation Information
After completing the installation of the repeaters, record the location of each repeater.
Holes for wall mounted screws
External antenna cable (only for repeaters
supplied with external antenna connection
Power supply cable
Repeater and external antenna
installed on the wall
External antenna (only for
repeaters supplied with
external antenna connection Repeater