PLUS Vision U7-137SF - Manual (Page 30)

E-30
General Operation
Using the Presentation Timer
Note:
* The timer display is not displayed when a menu or message is displayed or when the “Wireless Projector” setting screen is being projected,
but the timer continues functioning. The timer display is also not displayed when no signals are being input.
* While the presentation timer is being displayed, screen movement will not be possible in the zoom mode.
* Timer key operations cannot be performed when the input is set to “Image Viewer”.
[Timer settings display]
The presentation is given while checking the timer displayed
on the screen.
The gauge display allows the remaining time to be known at
a glance.
(1) Press the TIMER button to show the settings display.
The display will close when an operation has not been made
for about 10 seconds.
Press the CANCEL button to close the display immediately.
Movable Range of the Timer Display
FREEZE MUTE
LASER
AUTO
VOL ZOOM
RGB VIDEO
R-CLICK/
CANCEL
QUICK MENU
STANDBY
Q
1 2
3 4
TIMER
ENTER
(1)
(2)
(3)
CANCEL button
• Press the ENTER button to restart the timer. The timer will
start with the same time setting.
• Press the CANCEL button to close the timer display. The
timer setting will return to “Off”.
Moving the Position of the Timer Display
The SELECT (
̆̄̇̈) buttons on the remote control permit move-
ment within the movable range of the timer display.
(3) Press the ENTER button and start the timer.
• The display of the timer setting will close, the display of the
timer will appear and simultaneously the timer will start.
The blue gauge indicates the remaining time. When the
gauge disappears,the time is up.
The gauge continues to be displayed when the timer is
stopped.
[Timer Display]
Gauge (Blue)
When the remaining time is
“0” (Gray)
(2) Use the
̇ and ̈ SELECT buttons to set the time.
The setting contents are “Off” and from 10 to 60 minutes (in
10-minute intervals)
Settings can also be made with the SELECT (
̇̈) buttons.