PLUS Vision U7-137SF - Manual (Page 24)

E-24
Power Cable Connections and Switching the Power On/Off
Finishing
1
Switch off the power of the connected equipment
2
Switch off the power of the projector
Press the STANDBY button.
Warrning
Do not unplug the power cable while the STANDBY indicator is blinking amber. Doing so may shorten the life of the lamp
or damage the projector.
Power Off
OK ?
The STANDBY indicator changes to blinking amber and lights a steady
amber after about 90 seconds (when the unit enters the standby mode).
STANDBY STATUS
LASER
AUTO RGB VIDEO
QUICK MENU
Q
STANDBY
(button on main unit)
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen will
go off (in about 5 seconds) and the projector will enter the power-off
operation.
Note
* The operation can be cancelled by pressing a button other than the
STANDBY button.
* One more press of the STANDBY button will switch off the power.
Blinking amber
(Approximately 90 seconds)
Lit amber
Standby mode
STANDBY STATUS STANDBY STATUS STANDBY STATUS
Lit green
3
Unplug the power cable
Check that the STANDBY indicator is lit in amber and then unplug the power cable.
The STANDBY indicator will go off when the power cable is unplugged.