Panasonic KX-FT901BX - Manual (Page 47)

9. Programmable Features
47
9.2 Basic features
Code #01: Setting the date and time
SET DATE & TIME
See page 14 for details.
Code #02: Setting your logo
YOUR LOGO
See page 15 for details.
Code #03: Setting your fax number
YOUR FAX NO.
See page 17 for details.
Code #04: Printing a sending report
SENDING REPORT
To print a sending report for fax transmission
results (page 27).
“
ERROR” (default): A sending report will be
printed only when fax transmission fails.
“
ON”: A sending report will be printed after every
transmission.
“
OFF”: Sending reports will not be printed.
Code #05 (KX-FT901/KX-FT903 only):
Changing the receiving mode in the auto
answer setting
AUTO ANSWER
“ FAX ONLY” (default): Facsimile only mode
(page 36)
“
TEL/FAX”: Telephone/Facsimile mode (page
36)
Code #05 (KX-FT907 only): Changing the
receiving mode in the auto answer setting
AUTO ANSWER
“ TAD/FAX” (default): Telephone Answering
Device/Facsimile mode (page 35)
“
FAX ONLY”: Facsimile only mode (page 36)
“ TEL/FAX”: Telephone/Facsimile mode (page
36)
Code #06 (KX-FT907 only): Changing the ring
setting in TAD/FAX mode
TAD RING COUNT
To change the number of rings before the unit
answers a call in TAD/FAX mode. You can select
“
1”, “2” (default), “3”, “4”, “TOLL SAVER” or
“ RINGER OFF”. See page 35 for details.
Code #07: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select “
1”, “2” (default), “3” or “4”.
Code #09: Changing the TEL/FAX delayed
ring setting
TEL/FAX RING
If you use an extension telephone in TEL/FAX
mode, select the desired number of times the
extension telephone rings before the unit
answers the call. You can select “
1”, “2” (default),
“ 3” or “4”. See page 36 for details.
Code #10 (KX-FT907 only): Changing the
maximum incoming message recording time
RECORDING TIME
“ VOX” (default): Unlimited within the voice
memory capacity (page 60).
“
1 MIN”: Up to 1 minute.
Code #11 (KX-FT907 only): Setting the
remote operation ID
REMOTE TAD ID
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Press {SET}.
4. Enter any 3-digit number except a number
using 0 or 7.
L The default ID is “ 111”.
5. Press {SET}.
6. Press {MENU}.
Code #13: Setting the dialling mode
DIALLING MODE
If you cannot dial, change this setting depending
on your telephone line service.
“
TONE” (default): For tone dial service.
“ PULSE”: For rotary pulse dial service.
FT-901-903-907BX.book Page 47 Monday, March 29, 2004 10:03 AM