Configuring the next hop router for each vlan, Configuring static users, Dsl or mvl – Paradyne HOTWIRE 8310 MVL User Manual
Page 41
Configuring the Hotwire DSLAM
4-7
8000-A2-GB26-00
May 1998
Configuring the Next Hop Router for each VLAN
"
Procedure
To configure the default next hop router for each VLAN:
1. Select
Configuration
→
Bridge
→
Port VLAN (A-E-C).
2. Enter the port number at the
DSL Port #:
prompt.
3. Enter e to edit at the
Action(Edit/Activate/Deactivate):
prompt.
4. Enter the IP address of the default next hop router for this VLAN at the
Enter IP address of default next hop router
(nnn.nnn.nnn.nnn):
prompt.
5. Press Ctrl-z and save the changes.
Configuring Static Users
"
Procedure
To configure static users to get their peer address from DHCP:
1. Select
Configuration
→
Bridge
→
Client VLAN (A-E-D).
2. Enter the port number at the
DSL Port #:
prompt.
3. Enter 0 or press Return at the
Input Number:
prompt.
4. Enter the IP Address of this user at the
Enter Client IP address
(nnn.nnn.nnn.nnn):
prompt.
5. Enter the IP address of the default next hop router for this client at the
Enter IP address of default next hop router
(nnn.nnn.nnn.nnn):
prompt.
6. Enter the VLAN for this user at the
Input VLAN ID:
prompt.
7. Enter yes at the
yes/no:
prompt to save your changes.
NOTE:
For information on configuring dynamic users, see Chapter 3,
Service
Domain, in the Hotwire DSLAM for 8310 MVL and 8510 DSL Cards
Network Configuration Guide.