Configuring vlan(s) on a dsl or mvl card, Dsl or mvl, Selecting the active vlan on each dsl or mvl port – Paradyne HOTWIRE 8310 MVL User Manual
Page 40
Configuring the Hotwire DSLAM
4-6
8000-A2-GB26-00
May 1998
Configuring VLAN(s) on a DSL or MVL Card
"
Procedure
To configure at least one VLAN ID for this DSL or MVL card:
1. Select
Configuration
→
Bridge
→
Card VLAN (A-E-B).
2. Enter 0 or press Return at the
Item Number (0 to add new record):
prompt.
3. Enter the VLAN ID at the
Enter VLAN ID between 1 and 4094 or
space to delete:
prompt.
4. Enter enabled at the
Enabled/Disabled:
prompt in the Mux Fwd field.
(Default = enabled.)
5. Enter disabled at the
Enabled/Disabled:
prompt in the IP Filter field.
(Default = disabled.)
6. Enter enabled at the
Enabled/Disabled:
prompt in the IP Scoping field.
(Default = enabled.)
7. If desired, enter a domain name at the
Domain Name:
prompt.
8. Enter yes at the
yes/no:
prompt to save your changes.
NOTE:
For more information about the fields listed above, see Chapter 3,
Service Domain, in the Hotwire DSLAM for 8310 MVL and 8510 DSL
Cards Network Configuration Guide.
Configuring the Active VLAN on each DSL or MVL Port
"
Procedure
To configure the active VLAN on each DSL or MVL port:
NOTE:
You can configure only one active VLAN per port, but normally you assign the
same Next Hop Router.
1. Select
Configuration
→
Bridge
→
Port VLAN (A-E-C).
2. Enter the port number at the
DSL Port #:
prompt.
3. Enter a to activate at the
Action(Edit/Activate/Deactivate):
prompt.
4. Enter the number of the VLAN to be assigned to this port at the
Input
Number:
prompt. If you want a VLAN that spans several DSL or MVL cards,
you must specify the same VLAN number across all cards.
5. Press Ctrl-z and save the changes.