Psion Teklogix MLP 3040 Series - Manual (Page 9)

Getting Started
Battery Installation and Charging
Note: You must charge the battery for at least 2½ hours prior to the first use.
The battery for your MLP 3040 printer is shipped in an “uncharged” state. The battery must be charged using
the following instructions prior to using the printer for the first time. Maximum battery capacity is not reached
until after completing a minimum of three complete charge and discharge cycles.
Please refer to Figure 1 and insert the battery by sliding it into the battery compartment until the release lever on
the battery “snaps” into place.
Figure 1 - Battery Installation and Power Connector
Release Lever
Power Connector
Connect an optional power supply to the appropriate input source, and then connect the output of the power
supply to the printer’s Power Connector. The Battery Indicator will turn on and remain on until the battery is
fully charged. This may take up to 2½ hours.
Caution: Use only Psion Teklogix power supplies designed specifically for your MLP 3040 printer. Using a
different power supply may cause damage to the printer and will not be covered by the printer’s
warranty. Psion Teklogix power supplies are available for use with 100-240VAC/50-60Hz and
for12/24VDC vehicle applications.
3