Paradyne Hotwire 7975 - Manual (Page 62)

Testing
5-8 7975-A2-GB20-40 December 1998
Data Terminal Loopback
Data Terminal Loopback (DTLB) loops the user data back to the DTE. This
loopback is located as closely as possible to the user data port (DTE) interface.
98-15933
NTU/LTU
Network
Interface
Port
Interface
Framer
EIA-530
Port
CAP All 1s
"
Procedure
To run a Data Terminal Loopback:
1. Position the cursor at the Start command next to Data Terminal Loopback on
the SYNC Data Port Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command.
4. Press Enter.
Data Terminal Loopback cannot be started when a Repeater Loopback, DCLB, or
Remote DCLB is already active on the data port.