Philips FW-D1 - Manual (Page 10)

3139 115 20054
10
English
J Video Out Connection
Connect the VIDEO OUT (CVBS) terminal at
the rear of the system to the TV or VCR
VIDEO IN terminal for viewing or recording.
Note:
– You can also choose to connect the
S-VIDEO OUT (Y/C) terminal at the rear
of the system to the S-VIDEO IN of the
TV using an optional S-VIDEO cable.
K Audio Digital Out
Connection
You can record the digital sound from the
CD/DVD, through this output, on any audio
equipment with digital input (e.g. CD
Recorder, Digital Audio Tape (DAT) deck,
Digital to Analogue Converter and Digital
Signal Processor).
Connect one end of the cinch cable (not
supplied) to the DIGITAL OUT socket and
the other end to the audio equipment's
digital input. When connecting the cinch
cable, make sure it is fully inserted.
L Adjusting the Operating
Voltage (not available for all
versions)
Before connecting the AC power cord to a
wall outlet, make sure that the voltage
selector at the rear of the system is set to
the local power line voltage. If not, reset
the selector before connecting to the wall
outlet.
M AC Power Supply
After all other connections have been
made, connect the AC power cord to the
system and to the wall outlet.
PREPARATION
Inserting batteries into the
Remote Control
• Insert the batteries (Type R06 or AA)
into the remote control as shown in the
battery compartment.
• To avoid damage from possible battery
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type R06 or
AA batteries.
pg 001-41/D5-D1/21-Eng new 6/8/01, 11:32 AM 10