Philips DVP3200V/37B - Manual (Page 38)

English
38 Special Effects Playback
● Before you begin, press VCR so VCR light appears on the front
of the DVD/VCR.
Forward and Reverse Searching (SP/LP/SLP) /
Super High Speed Searching (LP/SLP)
1 During tape playback, press and release FFW g
or REW h. A fast forward or reverse picture search
will begin.
Press FFW g or REW h, then press again. The
search speed will increase. Repeatedly pressing FFW g
or REW h will switch between Regular and High Speed
Searching.
2 To return to normal playback, press PLAY B.
Viewing a Still Picture
1 During tape playback, press PAUSE k. A still picture
will appear on the screen.
2 To advance the still picture one frame at a time,
press PAUSE k repeatedly.
3 To release the still picture and return to playback,
press PLAY B.
• Still mode will switch to stop
mode after 5 minutes to
protect the DVD/VCR and the
tape from damage.
• SP/LP/SLP means this feature will
work with tapes recorded in
Standard Playback, Long Playback
or Super Long Playback. LP/SLP
means this feature will work with
tapes recorded in Long Playback
or Super Long Playback. Tape
speed details are on page 67.
Helpful Hints
TV/VIDEO VCR DVD VCR Plus+
SUBTITLE AUDIO ANGLE ZOOM
DVD
SETUP MENU
DISC/VCR
DISPLAY
BACK
PLAY
REW FFW
PREV NEXT PAUSE
REC STOP
OK
REPEAT
+
The following tape features are available in VCR mode. Press VCR so VCR light appears on the front of the DVD/VCR, if
necessary.
Automatic Playback
When you put a tape in the DVD/VCR, the power will come on. If the tape’s record tab is missing, playback will begin.
If a timer recording is set and “
” is flashing in the display panel, the power will not come on automatically when
you insert a tape with the record tab intact.
If a timer recording is set and “
” is flashing in the display panel, the DVD/VCR will eject the tape if the record
tab is missing.
Automatic Rewind, Eject
When a tape is played, fast forwarded or recorded to its end, the tape will rewind to the beginning, stop and eject
itself. This feature does not operate if AUTO REPEAT is ON. Details are on page 36.
Tape Eject
A tape can be ejected with the DVD/VCR power on or off (but the DVD/VCR must be plugged in).
If a timer recording is set and “
” is shown on the display panel, press TIMER SET on the remote control or
STOP/EJECT C A on the front panel to cancel the timer standby mode, and then press STOP/EJECT C A to
remove the tape. Remember to insert a tape and press TIMER SET to reset the timer recording.
Automatic Tracking Adjustment
The VCR adjusts tracking automatically to give you the best possible picture quality. With some recordings, however,
you may get a better picture using manual tracking.
Manual Tracking
To manually adjust the tracking during normal playback of a videotape, press CH + or CH - on the remote. Tracking
will return to Automatic Tracking when you press STOP C or insert a tape. You can also press CH + or CH - to
remove vertical jitter in a Still picture.
Automatic Operation Features
E8A21UD_EN1 5/29/06 3:13 PM Page 38