Paradyne ACCULINK 3161 CSU - Manual (Page 16)

14
Table 7. User Configuration Options (3 of 3)
Option Comments/Description Factory 2 Factory 1
5 5
TnDiscTm:
(Telnet Disconnect
Up Up
The period of inactivity (1 to
60 minutes) that causes a
(Telnet Disconnect
Time)
Down Down
60 minutes) that causes a
disconnect if TnInActTm is
enabled.
Save Save
enabled.
Table 8. Alarm Configuration Options (1 of 2)
Option Factory 1 Factory 2 Comments/Description
Alrm Msg:
Disab Disab Does not display alarm messages.
Alrm Msg:
Com Com
Sends alarm messages to COM
port.
SNMP Trap:
Enab Enab
Sends SNMP traps SNMP Trap:
Disab Disab
Sends SNMP traps.
TrapDisc:
Enab Enab Specifies whether the modem
connection will disconnect after a
TrapDisc:
Disab Disab
p
connection will disconnect after a
trap is sent.
DialOut:
Enab Enab Provides the option to allow
automatic dial out to send alarm
DialOut:
Disab Disab
p
automatic dial-out to send alarm
messages on MODEM port.
Call Retry:
Enab Enab Specifies whether an outgoing call
is retried on a busy or failed call
Call Retry:
Disab Disab
p g g
is retried on a busy or failed call
attempt.
Dial Delay:
1–4
5
6–10
1–4
5
6–10
The time (in minutes) to delay
between successive alarm
dial-outs or retry attempts.
AltDialDir:
None
1–5
None
1–5
The alternate dial-out directory to
use if a call to the primary number
cannot be completed.
10E–4 10E–4
10E–5 10E–5
Err Rate:
(Excessive Error 10E–6 10E–6 The error rate threshold for
Excessive Error Rate Alarm
(Excessive Error
Rate)
10E–7 10E–7
Excessive Error Rate Alarm.
Rate)
10E–8 10E–8
10E–9 10E–9