Panasonic CF-T2 Series - Manual (Page 77)

77
Wireless LAN
7
Select the profile you have set and select [Connect].
z If the setting of the profile that is currently connected is changed, the new setting
will not be enabled until you select the profile and then select [Connect].
8
Select [OK].
Open the Intel PROSet using either of the following procedures.
z Select [start] - [All Programs] - [Intel Network Adapters] - [Intel(R) PROSet for Wireless].
z Select or on the taskbar to check the communication status.
For more information about how to use the Intel PROSet, refer to [Help] in the menu bar.
If the function fails to operate correctly
Read the operating instructions for the access point carefully and check the settings.
„ The access point fails to be displayed in [Available Networks]
z Select [Networks], then select the profile you are using, and select [Advanced]. [Connect
to ad hoc networks only] may have been selected in [Connection preference]. In this
case, select [Connect to infrastructure and ad hoc networks].
z This computer uses channels 1 through 11 *1 . Check the channel being used by the
access point.
z Ask your system administrator or the person in charge of the network.
*1 In the case of wireless communications, the frequency band being used can be divided into
segments, so that different communications can be conducted on each band segment. A "Channel"
refers to the individual frequency bandwidth divisions.
„ The access point cannot be accessed
z The network key setting may not conform to the access point.
Check the network key setting of the access point and, if necessary, set it again correctly.
z Depending on the access point and settings, access may not be accepted unless the
computer's MAC address is registered beforehand. In this case, check the computer's
Check the Communication Status