Philips FW-V55 - Manual (Page 15)

3139 115 20042
15
English
Searching for a particular
passage during playback
• Press à or á to select 4 different
search speed.
™ "FRX1" ; "FRX2" ; "FRX3" or
"FRX4" is displayed on the TV
screen when you select a fast rewind
search.
™ "FFX1" ; "FFX2" ; "FFX3" or
"FFX4" is displayed on the TV
screen when you select a fast
forward search.
™ Normal playback will begin at the
end of the fast rewinding or
forwarding of the selected track.
• Play returns to normal when PLAYÉÅ
is pressed or when a new track is
selected.
Programming Tracks
Programming tracks of a loaded disc is
possible when playback is stopped. The
display will indicate the total tracks stored
in the program. Up to 99 tracks can be
stored in the memory in any order
(except
for MP3-CD). When 99 tracks are stored
and you attempt to store another track, the
display will show “
FULL”.
Note:
– Program cannot be used for VCDs when
PBC is switched on. Switch off PBC
before storing tracks from such a VCD.
1 Load the desired discs in the disc trays.
2 Press the VCD (CD 1•2•3) button to
select the disc tray.
™ Programming can only be done on the
selected disc.
3 Press PROG to start programming.
™ The PROGRAM starts flashing.
™ It will cancel any previously
programmed tracks and selected
repeat mode.
4 Pressí or ë (or digit 0-9 on the
remote control) to select the desired
track.
• For MP3-CD, press ALBUM - - - - -/+ + + + +
and TITLE - - - - -/+ + + + + to select the
desired Album and Title for
programming.
5 Press PROG to store the track.
• Repeat steps
4 to 5 to store other
tracks.
CD / VCD / MP3-CD
6 Press Ç once to end programming.
™ The total number of tracks
programmed and total playing time
appear on the display.
Notes:
– For MP3-CD, total playing time will not
be shown.
– If the total playing time is more than
“99:59” then “--:--” appears on
the display instead of the total playing
time.
– If the system is reading the disc,
programming is not possible,
“READING DISC” will be
displayed.
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Reviewing the program
Reviewing of program is possible only
when playback is stopped.
1 Press í or ë repeatedly to review
the programmed tracks.
2 Press Ç to exit review mode.
Playing the program
1 Press PLAY ÉÅ to start program
playback.
™ "PLAY PROGRAM" will be
displayed.
™ The track number and elapsed
playing time of the current track will
appear on the display.
• If you press REPEAT during program
playback, all programmed tracks will be
played repeatedly.
™ "PROGRAM" or "OFF" will be
displayed.
™ The REPEAT and PROGRAM appear on
the display.
2 Press Ç to stop program playback.
Note:
– If you press any other DISC DIRECT
PLAY buttons, the system will play the
selected disc or track and the stored
program will be cleared.
pg 01-28/V55/21-En 6/8/01, 9:11 AM 15