Plus Corporation UP-1100 - Manual (Page 5)

E – 5
a c c e s s o r i e s
Wired remote control cable (4m) [1]
For computer connection
PC/Macintosh multicable
(2m) [1] Monitor adapter
(for Macintosh) [1]
PC audio cable (2m) [1]
Carrying case [1]
Main unit
The bottom of
the unit
should face
this side.
How to use the carrying case
Notebook computer
and accessories
P r e p a r i n g t h e
r e m o t e c o n t r o l
Inserting the batteries
1 Press firmly
and slide the
battery cover
off.
2 Insert the sup-
plied two batter-
ies (size AA/R6).
Ensure that the
polarities (+ and
–) of the batteries
are aligned cor-
rectly.
3 Slip the cover
back over the
batteries until it
s n a p s i n t o
place.
Notes
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time, remove the
batteries.
• Do not mix new and old or different types of batteries.
• There are operations that can only be carried out by remote control.
Handle the remote control carefully.
Remote control effective range
Each side of the unit has a remote sensor as illustrated below.
The controllable range is 50 degrees horizontally and 30 degrees
vertically relative to a line that is at a right angle to the remote
sensor. And the distance between the point of the remote control
and remote sensor must be shorter than four meters.
Tip
You can also use the remote control as a wired remote control (see page
15).
are missing, contact your dealer. Please save the original box
Projector.
Accessory pocket
Power cable (mains lead)
(4m) [1]
30˚
30˚
50˚
50˚