Plus Corporation UP-1100 - Manual (Page 2)

E – 2
Precautions
Please read this man ual car efully before using y our PLUS UP-1100 Data Projector and kee p the man ual handy for future
reference.
Your serial number is located next to the main power switch on the back of your UP-1100. Record it here:
CAUTION
TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PLUS SERVICE PERSONNEL.
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EX-
POSE THIS UNIT TO RAIN OR MOISTURE. DO
NOT USE THIS UNIT’S GROUNDED PLUG
WITH AN EXTENSION CORD OR IN AN OUT-
LET UNLESS ALL THREE PRONGS CAN BE
FULLY INSERTED. DO NOT OPEN THE CABI-
NET. THERE ARE HIGH-VOLTAGE COMPO-
NENTS INSIDE. ALL SERVICING MUST BE
DONE BY QUALIFIED PLUS SERVICE PER-
SONNEL.
Important Safeguards
These safety instructions are to ensure the long life of your Data projector and to prevent fire and shock. Please read them carefully and heed
all warnings.
RF Interference
WARNING
The Federal Communications Commission does not allow
any modifications or changes to the unit EXCEPT those
specified by PLUS Technologies in this manual. Failure to
comply with this government regulation could void your
right to operate this equipment.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a com-
mercial installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harm-
ful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to
correct the interference at their own expense.
DOC Compliance Notice
This Class A digital apparatus meets all requirements of the Cana-
dian Interference-Causing Equipment Regulations.
Installation
• For best results, use your Data projector in a darkened room.
• Place the projector on a flat, level surface in a dry area away from
dust and moisture.
• Do not place your Data projector in direct sunlight, near heaters
or heat radiating appliances.
• Exposure to direct sunlight, smoke or steam can harm internal
components.
• Handle your Data projector carefully. Dropping or jarring can
damage internal components.
• Do not place heavy objects on top of the Data projector.
• If installing the Data projector in the ceiling:
– The ceiling must be strong enough to support the Data projec-
tor and the installation must be in accordance with any local
building codes.
– The Data projector must be installed by qualified PLUS ser-
vice personnel.
Power Supply
• The Data projector is designed to operate on a power supply of
100 to 120 or 220 to 240 V 50/60 Hz AC. Ensure that your power
supply fits this requirement before attempting to use your Data
projector.
• Handle the power cable carefully and avoid excessive bending. A
damaged cord can cause electric shock or fire.
• If the Data projector is not to be used for an extended period of
time, disconnect the plug from the power outlet.
Cleaning
• Unplug the Data projector before cleaning.
• Clean the cabinet periodically with a damp cloth. If heavily
soiled, use a mild detergent. Never use strong detergents or
solvents such as alcohol or thinner.
• Use a blower or lens paper to clean the lens, and be careful not to
scratch or mar the lens.
I M P O R T A N T S A F E T Y I N F O R M A T I O N