Pioneer AVIC-90DVD - Manual (Page 47)

45
Chapter 3
Editing the Navigation Utilities
Checking the Navigation Status
The navigation status, including the driving sta-
tus of a vehicle, positioning status by satellite,
learning status of the 3D sensor, and cable con-
nection status can be checked.
Checking sensor learning status
and driving status
1
Touch “Information” in the Main menu,
then touch “3D Calibration”.
The 3D Calibration screen appears.
1. Distance
Driving distance is indicated.
2. Speed Pulse
Total number of speed pulses is indicated.
3. Learning Status
Current driving mode is indicated.
4. Degree of learning
Learning situations of Distance, Right Turn,
Left Turn, and 3D detection are indicated by
the length of bars.
5. Speed
Speed detected by the navigation system is
indicated. (This indication may be different
from the actual speed of your vehicle, so
please do not use this instead of the speed-
ometer of your vehicle.)
6. Front and back G/Rotational speed
Accelerated velocity of your vehicle in front
/ back direction is indicated. Also, rota-
tional speed when your vehicle turns to left
or right is shown.
7. Inclination
Degree of slope of the street is indicated.
To clear values...
If you want to delete the learned results stored in
“Distance”, “Speed Pulse” or “Learning Sta-
tus”, touch the relevant result, then touch
“Clear”.
❒ The navigation system can automatically use
two types of sensor memory based on the
outer dimensions of the tires.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the main unit and the vehicle. Please also check
whether they are connected in the correct posi-
tions.
1
Touch “Information” in the Main menu,
then touch “Connection Status”.
The Connection Status screen appears. Either
“OK” or “NG” (or “No”) appears on the
screen, and the connection status of each
cable is shown.
1. Speed Pulse
The Speed Pulse value detected by the navi-
gation system is shown. “0” is shown while
the vehicle is stationary.
2. GPS Antenna
Indicates the connection status of the GPS
antenna, the reception sensitivity, and from
how many satellites the signal is received.
3. Installation Position
The Installation position of the main unit is
shown.
4. Parking brake
When the parking brake is applied, “On” is
displayed. When the parking brake is
released, “Off” is displayed.
1
2
3
4
5 7 6
1
2
3
4
5
6
7