Polaris 600 HO RMK 155 - Manual (Page 40)

37
FEATURES
Instrumentation
MFD Digital Display Programs
History Program
Service Interval Reminder
The gauge logs the number of engine hours
accumulated between service reminders.
When the logged hours reaches the desig-
nated service interval (set by the user), the
gauge provides a reminder that service is
due. "SErVCE" will flash in the odometer
area and "ENG" will flash in the icon area
for five seconds each time the engine is started (until the service
reminder is reset.) Use the following procedures to reset the reminder.
To reset the reminder at the existing interval:
1. Enter the History Program.
2. Press and release the SET button until the service interval screen is
active.
3. Press and hold the SET button for ten seconds, continuing to hold
even after the display begins to flash.
4. When the display stops flashing, release the button. The service
interval has been reset.
To reset the reminder at a new interval:
1. Enter the History Program.
2. Press and release the SET button until the service interval screen is
active.
3. Press and hold the SET button for five seconds, until the hours begin
to flash. Immediately release the button.
4. Press the button again, up to five times, to advance the reminder in
20-hour increments.
NOTE: The maximum interval is 200 hours.
To disable the service interval reminder, press the SET button once after
reaching 200 hours on the display. The gauge will display "OFF".