Pioneer S-DV900ST - Manual (Page 83)

Additional information 12
83
En
English
Italiano
Français
Nederlands
Español
Deutsch
DVD/CD/Video CD player
Timer indicator is
blinking and the
system will not switch
on. • Unplug the unit, then plug back in. Wait for one minute then switch on.
• Make sure the fan at the AMP section of the unit is not being blocked.
• Check that the speakers are connected correctly.
• If the problem persists, take it to your nearest Pioneer
authorized service center or your dealer for servicing.
Problem Remedy
Problem Remedy
The disc is ejected
automatically after
loading. • Clean the disc.
• Align the disc properly in the disc guide.
• If the region number on a DVD-video disc does not match the number on
the player, the disc cannot be used (see
DVD Video regions on page 78).
• Allow time for any condensation inside the player to evaporate. Avoid
using the player near an air-conditioning unit.
Playback is not
possible. • If the disc is loaded upside down, reload the disc with the label side face
up.
Picture playback stops
and the operation
buttons cannot be
used.
• Press (stop), then (play) to start playback again.
• Switch the power off once, then on again using the front panel
STANDBY/ON button.
Settings are canceled. • When the power is cut due to power failure or by unplugging the power
cable, settings will be canceled.
No picture/No color. • Check that connections are correct and that plugs are inserted fully.
• Check the instruction manual of the TV/monitor to make sure the TV/
monitor settings are incorrect.
• If your TV/monitor is connected using an S-video cable, try changing the
S-Video Out setting (see
S-Video Out on page 65).
Screen is stretched or
aspect does not
change.
• The TV Screen setting is incorrect. Set the TV Screen option to match the
TV/monitor you're using (see TV Screen on page 63).
When recorded on a
VCR or passed through
an AV selector, there is
disturbance in the
playback picture. • This system uses copy-protection technology which may prevent
recording or cause picture problems when connected through a VCR or AV
selector. This is not a malfunction.
NS03_ZFL.book 83 ページ ２００３年７月３１日 木曜日 午後７時０分