beautypg.com

Troubleshooting, General, Additional information 12 – Pioneer S-DV900ST User Manual

Page 82

background image

Additional information

12

82

En

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.

• If the system does not operate normally due to external effects such as static electricity

disconnect the power plug from the outlet and insert again to return to normal operating
conditions.

General

Problem

Remedy

The power does not
turn on.

• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the system to shut off automatically.

No sound is output
when a function is
selected.

• If you’re using the line input, make sure the component is connected
correctly (see

Connecting auxiliary components

on page 72).

• Press

MUTE

on the remote control to turn muting off.

• Adjust the

VOLUME

.

No image is output
when playing discs.

• Make sure the TV is connected correctly (refer to the Setup Guide).
• Reset the video output to interlace (see

Component Out

on page 64)

No sound from
surround or center
speakers.

• Refer to

Setting the channel levels

on page 59 to check the speaker levels.

• Check that you haven’t selected the

STEREO

sound mode (see

Listening

in surround sound

on page 30).

• Check that the Virtual mode is not on (

Using the Advanced Surround

effects

on page 32).

• Connect the speakers properly (refer to the Setup Guide).

Can’t operate the
remote control.

• Replace the batteries (refer to the Setup Guide).
• Operate within 23 ft. (7 m), 30° of the remote sensor on the display unit
(refer to the Setup Guide).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the display unit to direct light.

No display

• Make sure everything is connected properly.

NS03_ZFL.book 82 ページ 2003年7月31日 木曜日 午後7時0分

This manual is related to the following products: