beautypg.com

Pitco Frialator Electric Fryers SEH Series User Manual

Page 4

background image

L20-246 Rev 4 (05/13)

INSTALLATION INSTRUCTIONS

CAUTION:

This equipment is manufactured for the use on a

particular voltage and phase which is specified on

the rating plate located on the inside of the door.

When your fryers arrive, inspect carefully

noting any damage on the freight bill. If concealed

damage is found after you have accepted the

equipment, report it to the carrier immediately as

all claims must be filled within 15 days of the

receipt of the shipment. Also, be sure to keep all

packing materials as these will be necessary to

make any claim.

Follow these installation instructions care-

fully. A proper installation is important for the

operation of the fryers.

All installations must conform to all local and

national codes.

Do not block the area around the casters and

under the fryers. Contact the Authorized Pitco

Frialator representative for any service related

problems. Routine maintenance may be performed

by qualified personnel.

The duct system, the hood system and the

fryers must be cleaned on a regular basis and must

be kept clear of any grease build up.

Ventilation:

A proper ventilation system is also an impor-

tant part of the installation.

Clearances:

Minimum clearance of 6" (15cm) must be

maintained from combustible construction on each

side and the rear of the equipment. This equipment

may be installed on combustible floors.

Maintain a minimum of 24"(61cm) clearance

in front of the fryer to provide for proper opera-

tion, maintenance and servicing.

Wiring diagram(s) are located in the back of

the service manual and inside the fryers.

Regular cleaning of this equipment, as well as

the hood, is an important part of proper mainte-

nance.

Once the fryers are in place:

Leveling the fryers will help ensure proper

operation. To level the fryers loosen the two set

screws on the caster stem. Rotate the collar of the

caster to raise or lower the height of the unit.

Tighten set screws to lock the adjustment. Casters

should be adjusted so that the fryers are level and

at the correct height under the hood system.

1

This manual is related to the following products: