Philips 64PH9901 - Manual (Page 28)

A
UDIO
/V
IDEO
NTSC A
NALOG
C
ONNECTIONS
SYSTEM AUDIO OUT
STEREO IN
6 CHANNEL
AUDIO IN
R L
C
RS LS SW
AUDIO INPUT
PHONO INPUT
L R
DTV ANTENNA
DTV DIGITAL AUDIO OUT
ANALOG TV ANT/CABLE
AUX 1 AUX 2 S-VIDEO
ANALOG AUDIO OUT AUDIO INPUT AUX 1 AUX 2
VIDEO OUT VIDEO INPUT
L R L R IR BLASTER TV
SYSTEM AUDIO OUT STEREO IN
6 CHANNEL AUDIO IN
R L
C
RS LS SW
VGA IN
75 ohm HIGH SYNC
H/H + V V
R/Pr G/Y B/Pb HD COMPONENT VIDEO IN
INTERNAL TV SPEAKERS USED AS CENTER CHANNEL
CENTER CHANNEL INPUT
50 W MAX IN – +
NO YES SUBWOOFER
PREAMP OUT
FRONT SPEAKERS EXT INT
SUBWOOFER
SPEAKER OUT
– + FRONT EXTERNAL SPEAKERS OUT – + – + SURROUND EXTERNAL SPEAKERS OUT – + – + All External Speakers 8 ohms Min.
R L
R L
28
SYSTEM AUDIO OUTPUTS
REAR OF DPTV
T he DPTV's System Audio
Output jacks can be used for
sound playback through an
external audio amplifier or Dolby
Pro Logic receiver.
Connect the R(ight) and L(eft)
SYSTEM AUDIO OUT jacks on
the DPTV to the R and L Audio
Input jacks on your amplifier or
sound system.
Turn DPTV ON and place the
external amplifier system to the
AUX INPUT mode (if applicable).
Note: Dependent upon the audio
information received the DPTV
outputs a straight two channel
Left/Right stereo audio signal for
output.
STOP
1
2
BEGIN
AUDIO SYSTEM (or Dolby Pro Logic Receiver )
SPEAKERS USED FOR PLAYBACK SOUND
AUDIO INPUT JACKS
S
MART
H
ELP
Note: To eliminate sound
playback through the DPTV
cabinet speakers when using an
external amplifier audio connection
you can either:
-Press the MUTE button on the
Pronto remote to eliminate sound
through the DPTV speakers
OR
-Place the FRONT SPEAKERS
switch on the rear of the DPTV
to the EXT(ernal) position
(which will also eliminate the
use of the Front External
Speaker Out connection
terminals on the DPTV.)
The System Audio Out(put) jacks send the DPTV’s current audio
(ATSC, NTSC, or Monitor) to an external amplifier for output. The
advantage of such an additional System Audio Out connection (as
shown in this diagram) is that it could continue to route the supplied
audio signals from the DPTV to an external amplifier or Pro Logic
Receiver (even when the selected program source switches between a
digital ATSC program, NTSC, or Monitor supplied source). In the case
of digital multichannel audio the DPTV downmixes the audio output to a
straight 2-channel stereo signal.
Note: For best audio reproduction and playback of Dolby Digital
surround sound through a Pro Logic Receiver (when using the
System Audio Out jacks):
• place the REAR SPEAKER DELAY control (located in the DPTV’s
ATSC Speakers Menu) to the maximum 13 feet/4 meters setting
• place the Center Channel Delay control (located in the DPTV’s
ATSC Speakers Menu) to the “Center Back” position.