Perle Systems MEDIA CONVERTERS S-1110DPP - Manual (Page 7)

Perle PoE/PoE+ Ethernet Media Converter
Installation Guide
7
Power Sourcing Pinouts
Note: The factory settings for Power Sourcing Pinouts will
work for most installations as 802.3a and 802at-2009 (
POE/POE+) devices will detect and sync to the correct POE
option. However, in the rare case that you need to modify the
settings, the procedure is below.
When Power Sourcing is enabled on a copper port, the S-1110P
will provide power to the connected PD device over the Ethernet
cable (
see PSE function on Dip Switch configurations ). The
wire pairs on the cable used for delivering power will depend on
the device. The following options are available.
PoE Option
RJ-45
Alternative A Alternative B Legacy
1 positive
2 positive
3 negative
4 positive negative
5 positive negative
6 negative
7 negative positive
8 negative positive
UTP (copper) Power
PoE
•
IEEE 802.3af (PoE) up to 15.4 Watts per UTP port.
PoE+
•
IEEE 802at-2009 (PoE+)
•
Up to 30 Watts on a single UTP port model and up to
25.5 Watts per port on a dual UTP port model
•
PoE+ models will also support 802.3af PDs (Type 1)
and PoE+ PDs (Type 2)