Perle Systems MEDIA CONVERTERS S-1110DPP - Manual (Page 20)

Perle PoE/PoE+ Ethernet Media Converter
Installation Guide
20
4. Loosen the terminal block screws and connect Positive (+)
wire to the left terminal. Connect the Negative (-) wire to the
right terminal. Tighten Terminal screws (0.22Nm-0.25Nm
torque).
5. Plug the terminal block into the Media Converter
6. Turn on power source.
7. Check that the PWR LED light is lit.
8. For extra power cable strain relief, attach the strain clip to the
case as shown below, and thread the power cable through the
clip in either one or two loops.