Perle Systems MEDIA CONVERTERS S-1110DPP - Manual (Page 13)

Perle PoE/PoE+ Ethernet Media Converter
Installation Guide
13
Speed copper (Switch 5)
Switch Position Copper port 1 Copper port 2
Up (default) 100 NA
Down 10 NA
Note When Auto Negotiation (SW1) is set to Off, the media
converter will use this switch setting for copper port 1 speed.
100: When Switch 5 is in the Up position, the S-1110P will force
the speed to 100 Mbps.
10: When Switch 5 is in the Down position the media converter will
force the speed to 10 Mbps.
Auto Fiber Negotiation (Switch 6)
Switch
Position Fiber 1
1000 Mbps Fiber 2
1000 Mbps
Up (default) Auto Auto
Down Off Auto
Auto: The Media Converter will negotiate Ethernet parameters on
the fiber connection. This will ensure that the most optimal
connection parameters will be in effect. If connecting to another
Perle Media Converter, this parameter should be set to Auto. The
Media Converter Module will advertise 1000Mbps, Full and Half
Duplex, no Pause.
Off: The Media Converter Module’s fiber will be fixed to
1000Mbps, Full Duplex.
Note: Fiber port 2 is always set to Auto.
When using a 100 Mbps SFP module
Full/Half Duplex on Fiber (Switch 6)
Switch
Position Fiber 1
100 Mbps Fiber 2
100 Mbps
Up (default) Full Duplex Full Duplex
Down Half Duplex Full Duplex