beautypg.com

English – Pioneer DRM-7000 User Manual

Page 29

background image

29

En

English

Operation

2. Hot start

When discs have been transported to drives and the power
to the changer is turned off and then the power to the changer
is turned back on, then the discs will be automatically returned
to their original slots. (Note that this automatic disc return
operation is not performed after a SCSI bus reset.)
For discs which are accessed frequently, however, it is
possible to use the hot start feature to make those discs
accessible immediately after power is turned on by leaving
the discs in the drives which had used them.
Hot start function is an optional function and it enables to
leave discs on the drives that had been using when the power
is turning on.

Press the ENT key

Press the

| key to set to ON

Press the ENT key

(Note that a “Hot start is prohibited” message will be
displayed if hot start function is set to OFF.)

NOTE:
Hot start function cannot be used when the changer control
software is designed so as to force discs to be returned to
their original slots.

3. Auto eject

In network environments there are often times when
changers are installed near servers far from the locations in
which user terminals are located.
In environments such as these, when a user uses the changer
control software to issue a command requesting a disc within
a changer be removed through a mailslot, it is necessary for
the user to go to the location where the changer in question
has been installed in order to remove the disc, but before the
user reaches the changer the mailslot in which the disc has
been transported may already have been opened.
This may be convenient for some cases, however, unless a
system administrator resides near the changer it is as if there
were no security at all, and the same holds true of the ejection
of a hyper magazine.
This is the reason why it has been made possible to turn OFF
auto eject function. Placing restrictions on the automatic
ejection of mailslot tray and on the automatic ejection of a
hyper magazine, makes it possible to maintain a certain level
of security.

Press the ENT key

Press the

\ key to set to OFF

Press the ENT key

(Note that a “Auto eject is activated” message will be
displayed if auto ejection function is set to ON.)

If auto eject function is set to OFF and a command is issued
from the host computer causing a disc to be carried to a
mailslot, the mailslot tray will not automatically open, and
instead a message like the following will be displayed on the
LCD message window.

This manual is related to the following products: