beautypg.com

Pioneer DRM-7000 User Manual

Page 26

background image

26


En

Config submode

Config submode is the mode to browse the current status of
the magazine bays and the rear bays. It may be used to make
sure that all components currently installed in the changer
have been properly recognized by the changer.

Pressing the ENT key causes the display to switch to the
‘select bay’ screen. Press the

« or » key to select either the

magazine bay or the rear bay.

Operation when the rear bay has been selected

Pressing the ENT key first displays the component loaded in
rear bay #1.
¶ The bay number to be displayed is selected by pressing

the

» or « key.

Press

» or « key

Press

» or « key

Press

» or « key

¶ If the component that has been inserted in the bay

displayed is a drive unit, it is possible to read out the SCSI
ID, termination switch settings, and device ID of the drive
in question.
Press the ENT key when the displayed is the bay in which
a drive has been inserted, then it displays the above
information.

Operation

Inquiry submode

Inquiry submode is the entry to system administrator mode
and also the exit to user mode. Here the DRM-7000/DRM-
3000 displays information its own. The data displayed is the
same as that obtained when the host computer issues an
SCSI INQUIRY command to the changer. Your changer’s
current SCSI ID and the firmware revision is seen here.

Pressing the ENT key at this time then the changer’s model
name and device ID (i.e., serial number) to be displayed.

Pressing the ESC key causes the display to return one level
above from the message currently being displayed.

To change the changer’s SCSI ID, use the SCSI ID switch
located at the lower left at the rear of the changer.
When the setting value of the SCSI ID switch is altered, the
display will show a message like that shown below. (Note
that the message shown here is the message which would
be displayed when the SCSI ID is changed from ‘6’ to ‘5’.)

The SCSI ID will be updated only when the power to the
changer is turned OFF and ON or the host computer resets
the SCSI bus on which the changer is.

Example of display for DRM-7000

This manual is related to the following products: