Pioneer DRM-7000 - Manual (Page 19)

19
En
English
Installation
¶ Install 2 internal drives within the changer in a daisy-chain
configuration and connect the drives to the changer.
Total length of SCSI cables: approx. 2.1m
(Note that this does not include the length of the cable
running from the host computer to the changer.)
¶ Install 6 internal drives within the changer in a daisy-chain
configuration and connect the drives to the changer.
(Additional cable for 4 drives will be needed.)
Total length of SCSI cables: approx. 2.9m
(Note that this does not include the length of the cable
running from the host computer to the changer.)
¶ Connect 4 drives directly to the individual host adapters.
(Additional four single drive connector panels will be
needed and pre-attached multi drive connector panel may
be removed.)
¶ Install 4 internal drives within the changer in a daisy-chain
configuration and connect the drives to the changer.
(Additional cable for 2 drives will be needed.)
Total length of SCSI cables: approx. 2.5m
(Note that this does not include the length of the cable
running from the host computer to the changer.)
SCSI Cable Connection Example:
Drive 1
Drive 2
Drive 3
Drive 4
Host
Drive 1
Drive 2
Drive 3
Drive 4
Drive 5
Drive 6
Host
Drive 1
Host
Host
Host
Host
Host
Drive 2
Drive 3
Drive 4
Rear of changer
Cable for
2 drives
Cable for
4 drives
Single drive
connector panel
Drive 2
Drive 1
Host
Cable
Connector panel
Rear plate
Host computer
Changer board
Terminator ON
Terminator ON
Terminator ON