Miscellaneous, Configuration window, Hardware settings – Philips FMU-100 User Manual
Page 12

User Manual
Page 12
Notes:
o CPU load is nearly the same as while file recording
o In general, PCM, IMA ADPCM etc. require less CPU time than MP3
o Length of buffer is shown as the last item in Codec properties field in RX Radiator
configuration
o If loop recording was active during last RX Radiator session, it will start automatically again
when RX Radiator is launched again (even when active only as tray icon)
-
Save and name automatically
Toggles between two modes of saving of the recorded file. When the button is down, it will assign
name and save the recorded file without showing save dialog automatically. Otherwise you have to
specify the target location and /or the name of the recorded file.
4.1.9 Miscellaneous
-
Setup
Configuration window launcher. Click it when you want to change the
configurations of the RX Radiator.
-
Sleep
timer
Using this button you can directly schedule RX Radiator to switch off
in stipulated period of time (10, 20, 30, 60, 120, 300 minutes). You can also opt to shutdown
Windows after that period.
Small LCD display displays the remaining time and sleep mode (S for RX Radiator shutdown, W for
Windows shutdown.
Stay on top
Toggles
Always on top and ‘standard’ mode of the RX Radiator main
window.
-
Minimize
Minimizes the RX Radiator window either in taskbar or into tray.
-
Thin
window/Maximize
Switches between thin and standard window.
-
Power
off
Closes RX Radiator.
-
Menu
button
Left clicking shows the main context menu with list of the stations
and several commands that have the same purpose as the RX Radiator window buttons.
4.2 Configuration
window
Configuration window is separated into several tabs:
-
-
-
-
-
-
-
About
4.2.1 Hardware
settings
Here you can specify the basic hardware settings to setup the RX Radiator.