Perle Systems 5500208-41 User Manual
Page 34
Configuring Users
34
IOLAN DS1/TS2 CLI Reference Guide, Version 4.1
line-access
Specifies the user access rights to each IOLAN device line. Options are:
z
Read/Write—Users are given read and write access to the line.
z
Read In—Users are given access to read only outbound data, data that is going
from the IOLAN to the device.
The
on|off
option is only for 1-port models. You can disable line access in 2-port +
models by specifying
0
(zero).
phone-number
The phone number the IOLAN will dial to callback the user (you must have set
Callback
to
On
). Enter the number without spaces.
port
When the
User Service
is
Telnet
, this is the target port number. The default value will
change based on the type of
Service
selected; the most common known port numbers
are used as the default values.
service
The type of service that the user will use.
sess-timer
The amount of time, in seconds, that the
Session Timer
will run. Use this timer to
forcibly close a user’s session (connection). When the
Session Timer
expires, the
IOLAN will end the connection. The default value is
0
(zero), meaning that the session
timer will not expire (the session is open permanently, or until the user logs out). The
maximum value is 4294967
seconds. The
User Session Timer
will override the
Line
Session Timer
, with the exception of reverse Telnet sessions.