Perle Systems 5500208-41 User Manual
Page 18
Server Commands
18
IOLAN DS1/TS2 CLI Reference Guide, Version 4.1
banner
This parameter concerns the banner information (product name/software version). This
banner information is presented to a user with a login prompt. For security reasons, you
can turn off the display of this information. The default is
Off
.
break
Enables/disables the existing Reverse Telnet break signal and the out-of-band break
signals for TruePort. The default value is
Off
.
bypass-password
When set, authorised users who do not have a password set, with the exception of the
Admin user, WILL NOT be prompted for a password at login with
Local
Authentication
.
dhcp/bootp
Enables the DHCP/BOOTP client process in the IOLAN. By default, this is
disabled/off. If this is enabled, the server IP address parameter is disabled.
domain_name
Unique name for your domain, your location in the global network. Like Hostname, it is
a symbolic, rather than a numerical, identifier.
flush-on-close
When enabled, deletes any pending outbound data when a port is closed; as opposed to
maintaining the port to send pending data. The default value is
Off
.
internet
The IOLAN’s unique IPv4 network IP address. If you are using the IOLAN in an IPv6
network, this field can be left blank.
monitor-connection-every
Specify how often, in seconds, the IOLAN will send a TCP keepalive. This only applies
to line service types that support the keepalive feature. The default interval is every 30
seconds.
name
You must supply a name for the IOLAN.
netmask
The network subnet mask. For example, 255.255.0.0.
oem-login
When set, and a custom language file is in use, the login prompt will use the string
defined in the language file as the login prompt instead of the default prompt,
login:
.
password-limit
The number of attempts a user is allowed to enter a password for a serial port
connection from the network, before the connection is terminated and the user has to
attempt to login again. For users logging into the serial port, if this limit is exceeded,
the serial port is disabled for 5 minutes. A user with Admin level rights can restart the
serial port, bypassing the timeout, by issuing a kill on the disabled serial port. The
default value is
3
.