Philips CDR820/17 - Manual (Page 14)

Digital optical connections via a digital receiver
If you have a receiver with digital optical in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
1 Remove the dust caps from the digital optical connections of
both source and CD recorder. Keep the caps in a safe place.
2 Connect an optical fibre-optic cord
between the OPTICAL IN- and OUT
jacks of the set and optical in- and
output jacks on the digital receiver.
Make sure you insert both plugs
fully, until a click is heard.
➜ Any digital device, connected to the digital input jacks of the
digital receiver (e.g. CD and DVD) can now be used as
recording source.
Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
1 Connect a digital coaxial cord between the DIGITAL IN- and
OUT jacks on the set and e.g. the (digital) AUX in- and output
jacks on the digital receiver.
➜ Any digital device, connected to the digital input jacks of the
digital receiver (e.g. CD and DVD) can now be used as
recording source.
Power supply
The type plate is located on the rear of the set.
1 Check whether the power voltage as shown on the type plate
corresponds to your local power voltage. If it does not, consult
your dealer or service organisation.
2 Make sure all connections have been made before switching on
the AC power supply.
3 Connect the power cord supplied to AC MAINS ~ and to the
wall outlet.This switches on the AC power supply.
4 Press POWER to switch on the set.
➜ Welcome To PHILIPS Audio will be displayed.
0 Press POWER again to switch off the set.
When the set is switched off, it is still consuming some power.
To disconnect the set from the power completely, remove the
power plug from the wall outlet.
Demo mode
The demo mode displays various features of the set and will
start automatically when no key has been pressed for several
minutes or during Standby mode.
To cancel demo mode
0
Keep STOP 9 on the set pressed for at least 5 seconds.
➜ The demo mode is cancelled permanently.
3
1
CD RECORDER
1
DIGITAL
RECEIVER
2
2
CD RECORDER
DIGITAL
RECEIVER
Installation
14
English
xp CDR 820/17 eng. 30-08-2001 10:43 Pagina 14