Panasonic AJ-HD1800P - Manual (Page 71)

71
Function menus
(continued)
Different kinds of settings and information can be stored or
retrieved from an SD memory card. When
(CARD) is
pressed on the button is held
down, the function menu shown below is displayed.
[MENU/ERROR LOG/MULTI CUE]
SYSTEM MENU/SETUP MENU/
50PIN ASSIGN
MULTI CUE
ERROR LOG
z The available capacity on an SD memory card is in the
range from 8 MB to 2 GB.
z An SD memory card must be formatted on the unit.
z An SRAM card cannot be used.
z An SDHC memory card cannot be used.
Warning message 1
A warning message about the SD memory card is displayed.
NO CARD
No memory card is inserted.
UNFORMATTED CARD
The SD memory card is not formatted.
Warning message 2
PROTECT!
SD memory card protection is turned [ON].
ACCESS!
This is displayed for the editing operation of
(FORMAT),
(SAVE), (DELETE), (LOCK), and the file title
(CARD).
To insert an SD memory card
Insert an SD memory card (optional) into the SD memory
card slot on the front left side; make sure the card’s notch is
up.
Insert the SD memory card after confirming that the direction
of the SD memory card is correct. If the card does not slide
smoothly into the slot but meets some resistance, the card
may be upside down or the direction may be incorrect. Do
not forcibly push the card into the slot, rather confirm the
direction again, and then insert the card correctly.
To eject the SD memory card
After confirming that “ACCESS!” is not displayed on Warning
Message 2, push the SD memory card into the unit further.
When the SD memory card is ejected from the slot, remove
the card.
Notes on the following points for using and
storing the card.
z Do not use or store the card in a hot, humid place.
z Do not expose the card to water.
z Prevent electrification of the card.
z When “ACCESS!” is displayed on the Warning Message 2,
the unit is accessing the SD memory card. Do not remove
the SD memory card while it is being accessed.
F2
F
F1 SHIFT F2 F3 F4 F5 F6
Memory name
Memory selection cursor
Warning message 1
F1 SHIFT F2 F3 F4 F5 F6
File title (CARD)
File number
(CARD)
File title (VTR)
File number
(VTR)
Warning message 2
File status (CARD) File status (VTR)
F1 SHIFT F2 F3 F4 F5 F6
F1 SHIFT F2 F3 F4 F5 F6
File status (CARD) File status (VTR)
Blank No storage files are
present.
_ _ _ _ _
Storage files are present.
(Unlocked status) The target file is in the
unlocked status.
Storage files are present.
(Locked status) The target file is in the
locked status.
F1
F2 F4 F5
SD memory card slot