beautypg.com

Connecting the drive as the only scsi device, Fig. 5 – Pioneer DVD-U03S User Manual

Page 11

background image

En

11

CONNECTING THE DRIVE AS THE ONLY SCSI DEVICE

WARNING
The power supply of the personal computer must be turned off before
cables are connected.

Fig. 5

When no SCSI hard disk or other SCSI equipment is used, connect according to the
following connection method.

¶ Turn off the power supply of the personal computer.

¶ Set the SCSI ID number.

¶ Enable internal SCSI termination (switch #5 = ON).

¶ Connect the power supply cable from the personal computer. At the time of

connection, please pay attention to the cable polarity.

¶ Connect the SCSI interface cable. At this time, confirm that the pin 1 of the SCSI

connector is connected correctly to pin 1 of the cable.

¶ When a sound board is used, connect the audio output with an audio cable to the

sound board.

Pin 1

Power Cable

SCSI
Interface
Cable

Audio Cable

SCSI HOST

Adapter

Sound Board

To the power supply of
the personal computer

Into an expansion slot of
the personal computer