Panasonic KX-FL511AL - Manual (Page 41)

7. Programmable Features
39
“ ON” (default): The unit will print the Caller ID list
automatically after every 30 new calls (page 23).
“
OFF”: The unit will not print the Caller ID list, but
keep a record of the information for the last 30
callers.
Code #31: Activating the Distinctive Ring
feature
DISTINCTIVE RING
=OFF [ ±]
See page 34 for details.
Code #37: Receiving other size documents
AUTO REDUCTION
=ON [ ±]
To receive a fax document that is longer than
your recording paper.
“
ON” (default): The unit will fit received
documents onto your recording paper.
“
OFF”: The unit will print the original size.
Code #39: Changing the display contrast
LCD CONTRAST
=NORMAL [ ±]
“ NORMAL” (default): For normal contrast.
“ DARKER”: Used when the display contrast is too
light.
Code #41: Changing the fax activation code
FAX ACTIVATION
=ON [ ±]
If you use an extension telephone and wish to
use it to receive a fax, activate this feature and
program the activation code.
L This code is also used to receive a voice
message and a fax in the same call (page
32).
1. Press {MENU}.
2. Press {#}, then {4}{1}.
3. Press {A} or {B} repeatedly to select “ ON”.
4. Press {SET}.
5. Enter your code from 2 to 4 digits, using 0–9,
{*} and {#}.
L The default code is “; #9”.
L Do not enter “0000”.
6. Press {SET}.
7. Press {MENU}.
Code #44: Setting the memory reception alert
RECEIVE ALERT
=ON [ ±]
To alert you with a beeping sound when a
received fax document is stored into memory
due to some existing problem.
The slow beeps will continue until you clear the
printing problem and make sure the unit is
supplied with enough paper to print the stored
document.
“
ON” (default): You will hear a beeping sound.
“ OFF”: Deactivates this feature.
Code #46: Setting friendly reception
FRIENDLY RCV
=ON [ ±]
To receive a fax automatically when you answer
a call and hear a fax calling tone (slow beep).
“
ON” (default): You do not have to press {FAX
START} for fax reception.
“
OFF”: You have to press {FAX START} for fax
reception.
Code #58: Setting the original mode
ORIGINAL
=NORMAL [ ±]
To send or copy a document with faint or dark
writing, set this feature before starting
transmission or copying.
“
NORMAL” (default): Used for normal writing.
“ LIGHT”: Used for faint writing.
“ DARKER”: Used for dark writing.
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
=ON [ ±]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
“
ON” (default): To send a fax even if there is static
interference on the telephone line.
“
OFF”: Deactivates this feature.
Code #74: Setting the location where you use
this unit
LOCATION
=AUSTRALIA [ ±]
This setting must match your location.
“
AUSTRALIA” (default): To use in Australia.
“ NEWZEALAND”: To use in New Zealand.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON [ ±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones;
FL511AL.book Page 39 Tuesday, October 7, 2003 2:18 PM