Patton electronic 1088/K - Manual (Page 6)

6
2.0 GENERAL INFORMATION
Thank you for your purchase of this Patton Electronics product. This
product has been thoroughly inspected and tested and is warranted for
One Year parts and labor. If any questions or problems arise during
installation or use of this product, please do not hesitate to contact Pat-
ton Electronics Technical Support at (301) 975-1007.
2.1 FEATURES
• Multi-Rate Symmetric DSL
• Supports DTE Speeds from 64 kbps to 2.048 Mbps
• 2-wire Operation
• 120 ohm (RJ-48C) and 75 ohm (dual coax) G.703/G.704 terminations
• 2-Mbps G.703 Clear Channel (Unframed) or nx64 G.704 (Framed)
Operation
• SNMP Manageable as the CP (Customer Premises) modem when
connect to Model 1095RC
• Selectable AMI or HDB3 Line Coding
• LED indicators for DSL Link, E1/FE1 Link, LOS, TM, ER and NS
2.2 DESCRIPTION
The Patton Electronics mDSL Rocket offers the ability to extend G.703/
G.704 service over Multi-rate Symmetric Digital Subscriber Line technol-
ogy. Multi-rate DSL offers the ability to deliver the maximum bit rate that a
twisted pair line can accommodate. Now, ISPs, CLECs and corporate
enterprises can terminate G.703/G.704 (E1) service and either extend
nx64 G.703/G.704 service or provide a remote serial connection to a
router or switch when paired with Model 1088/C (V.35) or 1088/D (X.21).
As Model 1088/K receives data from E1 line, it extracts the E1 clock, and
delivers smooth clock and data to the remote DSL modem over a two-wire
DSL span. In a
network extension application , a remote 1088/K delivers
nx64kbps to 2 Mbps G.703 data and clocking to device with an E1 inter-
face. In a
network termination application , a remote Model 1088/C or
1088/D accepts this data and clock stream and provides nx64kbps data to
CPE with a V.35, or X.21 interface.
As a symmetric DSL NTU, Model 1088/K offers the same data rates in
both directions over a single pair of regular telephone lines using Carrier-
less Amplitude and Phase (CAP) modulation. Equipped with 75 ohm (dual
coax) and 120 ohm (RJ-48C), the Model 1088/K is easy to configure and
install. DSL line connection is via RJ-45 jack. Standard versions of Model
1088 are powered by a 100/230VAC (Universal) supply. A DC power sup-
ply option supports any DC input between 36–72VDC.