Pentax AF-360FGZ User Manual
Page 43
41
(Preparation of Flash Unit Attached to Camera)
Firstly, set the wireless mode and channel of the
AF360FGZ attached to the camera, and register
the channel on the camera.
Attach the AF360FGZ to the hot shoe of the
camera after turning the camera off.
Set the power switch of the flash unit to
(WIRELESS).
Set the wireless mode switch to (M), so that
MASTER is displayed in the upper right corner
of the LCD panel.
Slide down the setting switch to the (yellow
dot) to display the channel on the LCD panel.
Press the channel button (CH) and select a
channel from 1CH to 4CH.
When Using Both an AF360FGZ Attached to the Camera and a Separated Flash Unit as
Main Flashes
Use both flash units as main flashes
1
00_AF360FGZ.book Page 41 Tuesday, June 13, 2006 12:09 PM