PLUS Vision DLPTM Technology Projector - Manual (Page 2)

User’s Manual
Copyright II
Copyright
Copyright © 2002. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a
retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical,
magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company.
Disclaimer
This Corporation. makes no representations or warranties, either expressed or implied, with respect to the contents
hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Further, this
company reserves the right to revise this publication and to make changes from time to time in the contents hereof
without obligation of this company to notify any person of such revision or changes.
Fill this in!!
For the convenience of service, record the following information in the space below. The serial
number is on the back of the product.
Monitor Information
Product Name:
Serial Number:
Date of Purchase:
Dealer Information
Dealer:
Telephone
Number:
Address:
Caution
TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER –SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED PLUS SERVICE PERSONNEL. AND PLEASE
READ ALL OF THESE INSTRUCTIONS BEFORE YOU OPERATE YOUR PROJECTOR. SAVE
THESE INSTRUCTIONS FOR FUTURE REFERENCE .
Safety Instructions
1. Read all of these instructions before you operate your projector and save for future reference.
2. The lamp becomes extremely hot during operation. Allow the projector to cool for approximately 45 minutes prior
to removing the lamp assembly for replacement. Do not operate lamps beyond the rated lamp life. Excessive
operation of lamps beyond rated life could cause them to explode in rare occasions.
3. Power is still available when the projector is in the standby mode. Never replace lamp assembly or any electronic
components unless the projector is unplugged.
4. Do not attempt to service this product yourself, as opening or removing covers may damage the components inside
and will void your warranty.
5. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the
product.
6. The Standard Remote Control contains a low-power laser that acts as a pointing device during presentations. The
light beam may cause injury if pointed directly into a person’s eyes.
7. This product is capable of displaying inverted images for ceiling mount configurations. Please use suitable equipment
for mounting the unit and make sure it is securely installed.
8. Openings in front or at two sides are for ventilation. They must not be blocked or covered.
9. For ventilation reasons, the fan continues to operate for about 1 minute after the projector has been powered off.
Please do not unplug the power cord until the fan stops.
10. Do not look straight at the projector lens during operation. The intense light beam may injure your eyes.