POLAR F92tiTM - Manual (Page 5)

46 ENGLISH
1. HOW THE POLAR HEART RATE MONITOR WORKS
Polar WearLink™ Transmitter:
1. Moisten the electrode areas of the strap under running water
and make sure that it is well moistened.
L
R Electrode areas
Connector
Polar WearLink Strap
2. Attach the connector to the strap. Position the connector’s
letter R to the word RIGHT on the strap and snap the fastener.
3. Adjust the strap length to fit snugly and comfortably. Secure
the strap around your chest, just below the chest muscles, and
snap the second fastener.
4. Check that the wet electrode areas are firmly against your skin
and that the Polar logo of the connector is in a central, upright
position. It is important that the electrode areas are wet during
exercise.
It is recommended that you wear the transmitter against your bare skin to
ensure flawless operation. However, if you wish to wear the transmitter over
a shirt, moisten the shirt well under the electrodes.
See care instructions of the WearLink Transmitter in chapter 9.
Care and maintenance, page 71.