POLAR F92tiTM - Manual (Page 31)

72 ENGLISH
4. Place the negative (-) side of the battery against the connector
and the positive (+) side against the cover.
5. Put the battery in the connector’s niche and put the cover on so
that the arrow points to the OPEN position. Make sure that the
cover’s sealing ring is placed correctly in its groove.
6. Gently press the cover deep enough so that its exterior surface is
on the same level as the connector’s surface.
7. Turn the cover with the coin clockwise so that the arrow on the
cover turns from OPEN to CLOSE. Make sure that the cover is
closed properly!
In order to ensure the maximum life span of the connector’s battery cover,
open it only when you need to change the battery. You can get the sealing
ring/battery kits from well-equipped Polar retailers and authorized Polar
Services. In the USA and Canada: Additional sealing rings are available from
an authorized Polar Service Center.
Polar Wrist Unit
The estimated average battery life of the Polar wrist unit is
20 months in normal use (1 h / day, 7 days a week). Note also that
excessive use of the backlight and the alarm signals will use the
battery more rapidly.
Do not open the Polar wrist unit yourself. To ensure the water
resistance properties and the use of qualified components, the wrist
unit battery should be replaced only by an authorized Polar Service
Center. At the same time a full periodic check of the Polar Heart
Rate Monitor will be done.
9.3 SERVICE
We recommend that you have all service done by an authorized
Polar Service Center only.
Water resistance cannot be guaranteed after unauthorized service.