POLAR F92tiTM User Manual
Page 14
55
ENGLISH
2.3 SETTING THE WATCH
Quick enter to the Watch setting loop: In the Time of day display press and
hold the
button for a couple of seconds.
If you want to skip some parts and go directly to set a particular watch
function, press START/STOP/OK until the desired watch function is displayed.
To return to the Time of day display at any stage of watch settings, press and
hold START/STOP/OK.
The digits run faster if you press and hold the
Up or
Down.
Release the button at the desired value.
Setting the Alarm
1. In the Time of day display press Up or Down until OPTIONS
is displayed.
2. Press START/STOP/OK to enter the Options mode.
USER SET is displayed.
3. Press Up or Down until WATCH SET is displayed.
4. Press START/STOP/OK to start the watch settings.
ALARM is displayed.
ON or OFF is flashing.
5. Press Up or Down to set the alarm ON or OFF.
When the alarm is turned on
appears on the display.
6. Press START/STOP/OK to lock your selection.
If you have 12h time mode, AM or PM starts to flash.
7. Press Up or Down to select AM or PM.
8. Press START/STOP/OK to lock your selection.
The hours start to flash.
9. Press Up or Down to adjust the desired hour.
10. Press START/STOP/OK to lock your selection.
The minutes start to flash.
11. Press Up or Down to adjust the desired minutes.
12. Press START/STOP/OK to lock your selection.
Choose from the following two alternatives to continue:
1. To set the time of day continue in chapter Setting the time
of day.
2. To return to the Time of day display, press and hold
START/STOP/OK.
When the alarm comes on, it will sound for one minute or you can turn it
off by pressing any of the four buttons.