Linksys WPS11 User Manual

Page 21

4. Click Save to create the IPP port on your system. You will see a message

confirming that the port has been created, then Figure 8-2:

5. Either select an existing printer to use the new port, and click OK.

Click the Add New Printer button to create a new printer to use the IPP
port. This will start the Add Printer wizard. Follow the prompts to complete
the process. Ensure that the new printer uses the IPP port.

Installation is now complete.

· To create additional IPP Ports, repeat the entire procedure.

· The Proxy Server and other options are set individually for each IPP Port.

Changing the IPP Port Settings

After the IPP port is created, you can reach the Configure IPP Port screen by:

1. Open the Printers folder (Start - Settings - Printers).

2. Right-click the IPP Printer and select Properties.

Wireless PrintServer

Figure 8-2

IPP Client Configuration for Windows 95/98/Millennium/NT 4.0/2000/XP

1. Run the Add IPP Port program entry created by the installation. A screen

like the one shown in Figure 8-1 will be displayed. If you do not see the Add
IPP Port program entry, then click Start. Select Programs and then IPP
Port Monitor. Click Add IPP Port.

1. If Internet access from your location is via a Proxy Server, check Access IPP

Server via Proxy Server, and enter details of your Proxy Server. (This will
be the same as your Browser configuration.)

2. Enter the IP Address or URL of the IPP Server.

3. Click Select Device Port to view the available ports on the IPP Server and

select the appropriate port. A connection to the IPP Server will be estab-
lished at this time.

Instant Wireless™ Series

Figure 8-1