Lennox Hearth GRANDVIEW GV230 User Manual

Page 23

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Door Gasket

Glass Retainer

Hex Head Screws

10 ea.

Glass with Gasket

Upper

Hinge Pin

Lower

Hinge Pin

Back View of Door

Back View of

Doorframe

tio

rts

DO NOT: Install or operate the stove or fireplace insert before reading this manual.

DO NOT: Close the draft beyond the point at which the flames are completely extinguished.

DO NOT: Open the stove or fireplace insert door without fully opening the draft first.

DO NOT: Burn driftwood or wood that has been in salt water. This includes some mill ends and scrap lumber that has been floated in salt water

on the way to the mill. (This will void your warranty).

DO NOT: Handle the Nickel Door Trim unnecessarily. Use the door handle only.

DO NOT: Force oversized logs into the firebox as this may dislodge the baffle assembly.

DO NOT: Close the door tightly during Burn-In Period.

DO:

Be sure to clean any fingerprints from optional accessories that have plated surfaces before burning the appliance. Clean the plated

surfaces only with household type glass cleaner and a very soft cloth.

DO:

Consult local building department if other than recommended clearances are desired.

DO:

Read instructions for the baffle boards occasionally to ensure you have not bumped or moved them out of place when loading wood.

DO:

Check the chimney and baffle monthly to make sure they are clean.

DO:

Burn seasoned, dry wood only! (RAIN = WET WOOD)

DO:

Open the door frequently during Burn-In Period to keep gasket from adhering to the curing paint.

DO:

Enjoy the warm feeling of your new Country

Collection stove.

DO’S AND DON’TS

GLASS REPLACEMENT INSTRUCTIONS

(Refer to Figure 30)

Step 1. Remove Door Assembly - Remove the upper and lower hinge

pins by pressing the bottom of each hinge pin up, then pull out

from the top. Lift off door and place face down on a soft surface.

Step 2. Remove Glass Retainer Screws (10 ea.) - Using an 1/8” allen

wrench remove the ten glass retainer screws. To locate screws,

peel back the door gasket as necessary. The screws are located

by the holes in the stainless steel glass retainer strips.

Step 3. Remove Glass - Carefully remove broken glass one piece at a

time (protective leather gloves are recommended).

Step 4. Clean Door Frame - Clean the area of the door frame where the

new glass with gasket will be installed.

Step 5. Install New Glass Assembly - Install the new glass with gasket

(use only factory supplied 5mm ceramic glass with gasket. Do

not substitute).

Step 6. Reinstall Retainer and Screws - Carefully reinstall the glass

retainer and screws. Be very careful not to overtighten the screws

(this could result in glass breakage when the stove is hot).

Step 7. Reinstall Door - Align hinges on door frame with corresponding

hinge holes on the face of stove. Reinstall the upper and lower

hinge pins from the top.

MAINTENANCE

Figure 30 - Glass Replacement

Locate screws (10 ea.)

(peal back gasket as shown)

Arrows indicate

screw locations