LSI SATA 150 - Manual (Page 7)

Preface vii
Copyright © 2002–2006 by LSI Logic Corporation. All rights reserved.
Related Publications
MegaRAID Device Driver Installation User’s Guide
Document Number: DB11-000018-02
This document explains how to install the MegaRAID device driver for
your operating system. The information in this document is independent
of the back-end bus and applies to both MegaRAID SCSI storage
adapters and Serial ATA storage adapters.
MegaRAID Configuration Software User’s Guide
Document Number: DB15-000269-01
This document explains how to use the RAID system configuration,
monitoring, and management tools that MegaRAID provides. These tools
include the BIOS-based MegaRAID Configuration Utility and WebBIOS
Configuration Utility, as well as the MegaRAID Manager OS-based tool
and the Power Console Plus OS-based tool. The information in this
document is independent of the back-end bus and applies to both
MegaRAID SCSI storage adapters and Serial ATA storage adapters.
Revision History
Revision Date Remarks
1.5 July 2006 Corrected text about the J4 Write Pending connector for the SATA
150-6 and SATA 150-4 controllers. Updated jumper information to
state not to use a jumper on the J1 connector for SATA 150-6 and
SATA 150-4. In addition, updated contact information for Technical
Support.
1.4 September 2004 Added information about drive roaming, drive migration, and
alarm beep codes. Did general editing on the document.
1.3 November 2003 Added a note about operating system support, logical drive dele-
tion, and headings for RAID Configuration Utilities and Technical
Support in Chapter 1. Corrected version number for the Serial
ATA specification (1.0).
1.2 September 2003 Added enclosure management information and updated the list of
supported operating systems.