LSI SATA 150 - Manual (Page 29)

After Installing the Storage Adapter 2-5
Copyright © 2002–2006 by LSI Logic Corporation. All rights reserved.
Step 8. Replace the computer cover, reconnect the power cord and
network cables, and power up the system.
During boot, the MegaRAID BIOS message appears:
MegaRAID BIOS Version x.xx date
(c) Copyright 2002, LSI Logic Corporation, USA
MegaRAID SATA Adapter Card found at PCI Bus No:xx
Dev No:xx
The firmware takes several seconds to initialize while the
adapter scans the Serial ATA ports.
2.5 After Installing the Storage Adapter
After you install the storage adapter, you must install the device driver
and define the logical drives and physical disk arrays. Refer to the
MegaRAID Device Driver Installation User’s Guide for detailed device
driver installation steps. Refer to the MegaRAID Configuration Software
User’s Guide for detailed instructions on how to configure physical arrays
and logical drives.