LSI SATA 150 - Manual (Page 27)

Detailed Installation Instructions 2-3
Copyright © 2002–2006 by LSI Logic Corporation. All rights reserved.
2.4 Detailed Installation Instructions
Here are detailed installation instructions for installing the SATA 150
storage adapter.
Step 1. Unpack the SATA 150 storage adapter and inspect it for
damage.
Unpack and install the storage adapter in a static-free
environment. Remove it from the anti-static bag and inspect it
for damage. Contact LSI Logic or your MegaRAID OEM
support representative if the storage adapter appears
damaged.
Step 2. Power down the system and remove the cover.
Turn off the computer and physically remove the power cord
from the back of the power supply. Remove the cover from the
computer chassis.
Step 3. Configure the jumpers on the SATA 150-6 or SATA 150-4
storage adapter.
Chapter 3, “SATA 150 Storage Adapter Characteristics” lists
jumper definitions and locations. The SATA 150-2 does not
have any jumpers.
Step 4. Insert the MegaRAID SATA 150 storage adapter in a PCI slot.
Be sure you are properly grounded, so you do not damage the
adapter with static electricity. Press down gently but firmly to
properly seat the storage adapter in the slot, as shown in
Figure 2.1 .