LSI 40909G-S User Manual
Page 34
3-16
Software Installation
itmpt
memory to read configuration data.
The driver was unable to allocate memory required to process
the configuration data. This means that the configuration was
not properly determined. To fix this you may need to manually
configure the driver using the itmpt.conf file.
itmpt
notification callbacks.
The itmpt was unable to notify the target device driver of a bus
reset. The target driver may start to malfunction.
itmpt
failed
The operating system failed to respond to the named routine in
a known manner. This is a fatal error that is not recoverable.
Please report this error to technical support.
itmpt
–
itmpt
–
itmpt
xxh unknown/impossible.
–
itmpt
ddi_dma_buf_bind_handle:
DDI_DMA_INUSE impossible.
–
itmpt
ddi_dma_buf_bind_handle: xxh
unknown/impossible.
–
itmpt
Hardware contains no valid license.
The adapter is not a valid LSI Logic/IntraServer adapter
licensed for use with Solaris.
itmpt
supported.
The adapter is in a slot that cannot be used with this driver.
Please try moving the adapter to a different PCI slot.
itmpt
and is unusable.
–
itmpt
adapter will not be installed.
Because of one of the previous two errors, this adapter could
not be "attached" to the I/O subsystem and will not be
accessible. See the previous error message and solve that
problem.
itmpt
state structure.
The driver was unable to initialize a required data structure and
therefore did not load. Please call technical support.
itmpt
handler.
The driver was unable to initialize the interrupt handler as
required. Please call technical support.
Table 3.2
Error Messages (Cont.)
Error Messages
Explanation