LSI 40909G-S - Manual (Page 21)

Installing the Sun SPARC Solaris Fusion-MPT™ Drivers 3-3
Step 2. When the banner is displayed, press the Stop-A keys to
interrupt the boot process and stop at the
ok prompt.
Step 3. Use the show-devs command to list the system devices. You
should see an output similar to the following example, as shown
in
Figure 3.1 :
Figure 3.1 System Devices Listing
Note: /pci@1f,0/pci@1/pci@2/IntraServer,fc@4
identifies the first FC interface on an
LSI Logic/IntraServer 7000 Series adapter.
The above is an example. The output of show-devs may
vary depending on your system and configuration. Use the
corresponding entries on your system, not those given
here.
If these devices are not listed, check that the adapter is correctly
installed, and reseat the adapter if necessary.
ok show-devs
/SUNW,UltraSPARC-IIi@0,0
/pci@1f,0
/virtual-memory
/memory@0,10000000
/aliases
/options
/openprom
/chosen
/packages
/pci@1f,0/pci@1
/pci@1f,0/pci@1,1
/pci@1f,0/pci@1/pci@2
/pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1
/pci@1f,0/pci@1/pci@2/IntraServer,fc@4
/pci@1f,0/pci@1/pci@2/IntraServer,fc@4/disk
/pci@1f,0/pci@1/pci@2/IntraServer,fc@4/tape
/pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1/tape
/pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1/disk
/openprom/client-services
…