LSI 40909G-S - Manual (Page 25)

Installing the itmpt Sun SPARC Solaris FC Driver 3-7
To clear an entry in the persistent device map, use the
clear-persistent command, as shown in Figure 3.4 :
Figure 3.4 Clearing an Entry
Entry 1 has been deleted from the table, and the table is now empty.
3.1.6 itmpt Device Driver
The LSI Logic/IntraServer itmpt driver is designed to Sun Microsystems
SCSA specifications for device drivers. This driver allows connection of
FC devices to LSI Logic/IntraServer adapter cards on PCI-based
machines.
The following sections describe the procedures to install the driver on
Solaris.
3.2 Installing the itmpt Sun SPARC Solaris FC Driver
The LSI Logic LSI40909G-S uses the itmpt FC driver for Solaris. This
driver is included with your adapter kit.
Note: If you plan to use an LSI Logic/IntraServer FC adapter for
your
system disk, you must use the installation procedure
as described in Section 3.2.2, “Network Installation Proce-
dure,” in order to load the device driver during installation.
3.2.1 Existing System Installation
These instructions provide details to install the LSI Logic/IntraServer
itmpt driver to an existing Solaris operating system installation.
Note: You must be logged on as root to perform the installation.
ok 1 clear-persistent
Entry 1 has been cleared
ok show-persistent
ok