Lobos Tech LB-FEA800M - Manual (Page 11)

Off
Half-duplex mode or no
device attached.
Table 2-1. The description of LED Indicator
Rear Panel
The Console port and 3-pronged power plug are located at the Rear Panel of
the LB-FEA800M as shown in Figure 2-3. The Switches will work with AC in
the range 100-240V AC, 50-60Hz.
Figure 2-3 The Rear Panel of the LB-FEA800M
Console Port: Console management can be done through the Console Port.
It requires a direct connection between the Switch and an end station (PC) via
a RS-232 cable.
Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby. The
surface where you put your Switch should be clean, smooth, level, and sturdy.
Make sure there is enough clearance around the Switch to allow
attachment of cables, power cord and air circulation.
Attaching Rubber Feet
1. Make sure mounting surface on the bottom of the Switch is grease and
dust free.