Lennox Hearth VIS35 - Manual (Page 7)

7
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
14-3/4”
(375mm)
22-1/2”
(572mm)
27-3/8”
(695mm)
d
imensions
The gas line screws into the gas valve at the back of the
stove 5” in from the right side of the stove and 4-3/16” up
from the base of the unit.
p
reparing
y
our
v
intage
™ s
tove
f
or
i
nstallation
Read all instructions before beginning your installation. If
instructions have not been read carefully, your installation
could void your warranty and may create a serious fire,
health, or other safety hazard.
The Lennox Hearth Products warranty will be voided if one
of the following occurs:
• Installation of any damaged stove or vent system
component.
• Unauthorized modification of the direct vent system.
• Installation other than as instructed by Lennox Hearth
Products, Security™ Chimneys, or Simpson Dura-
Vent.
• Installation of any stove or vent system component not
manufactured or approved by Lennox Hearth Products,
Security™ Chimneys, or Simpson Dura-Vent.
When planning the installation for your Vintage, it’s neces-
sary to consider the following:
• Where the unit is to be installed
• The vent system configuration to be used
• Gas supply (NG or LP)
• Electrical wiring
• Optional accessories (blower, wall-mounted or remote
thermostat, cast-iron panels or stove panel inserts)
t
op
v
iew
f
ront
v
iew
Figure
Figure
21-3/8”
(543mm)
Rear Vent Dimensions
24-5/8”
(626mm)
s
ide
v
iew
Flue Collar
C/L
Figure 1
p
ipe
C
learanCes
All installations using a vertical termination cap must
maintain one inch clearance between the direct vent pipe
and combustibles. For horizontal runs of pipe, one inch of
clearance to combustibles on the sides and bottom, and two
inches on the top of the pipe is required. See pages 13, 14
and 15 for allowable pipe configurations.